In this article, we will discuss the recommended maintenance to ensure your CO2 laser engraver machine is working at its best performance.

Laser Machine Installation Guide (320 Basic & 640 Basic Models)

The installation process for the 320 Basic and 640 Basic laser cutting machines is similar, with potential variations in hose and plug positions depending on the model.

Step-by-Step Guide:

1. Connect Water Pump: Attach the two white hoses. One goes to the water pump, the other to the water container (filled to 3/4).

2. Connect Air Pump: Attach the "Air Assist" hose to the silver air pump for smooth cutting and engraving.

3. Install Air Ventilation: Set up the ventilation system at the back to expel dust and smoke.

4. Connect Power Cable: Plug into the machine, but avoid sharing with high-power devices.

5. Obtain Machine ID: Find the ID number on the motherboard.

6. Connect USB Cable: Link the machine to your computer.

7. Insert Orange Dongle: Ensure the dongle is connected for machine operation.

8. Turn on the Machine: The setup is complete and your CO2 Laser Engraving Machine is ready to use.

Now, you're all set to start creating your products!

To use the Laser Engraving Machine, you need to master on how to use CorelLaser software.   It might seem hard at first, but with continues effort and interest, you will definitely be an expert in using it in a short time.    You can download the CorelLaser software HERE....

This configuration needs to be done when you install the CorelLaser software only once Follow the simple steps shown below, remember Don't Skip This StepStep 1 : Open CorelLaser softwareStep 2 : CorelLaser interface All operations use the tools at the top left Step 3 : Click the CorelLaser Setting...