The installation of the laser cut machine for the 320 Basic and 640 Basic models are similar. however, there may be differences in the position of hoses/plugs depending on the current model. 

This article is very useful for theose looking for a Laser Machine Installation Guide, whether you are a LasercutMY custromer or purchasing a machine directly from China. 

Step 1: Connect the water pump. 

There are 2 white water hoses located at the back of the machine. One hose connects to the Water Pump, while the other is directed into the water container. The water should be filled to about 3/4 of the height of the container.

You are reminded to always ensure that water is flowing while the machine is operating. This Water Pump gets its power source from the Laser Machine.

Step 2 : Connect the Air Pump 

The Air Pump is silver and helps the cutting and engraving processes run smoothly. There is a black/white hose labeled "Air Assist" that needs to be connected to the Air Pump. This Air Pump also gets its power source from the Laser Machine.

Step 3 : Install the Air ventilation 

The ventilation channels dust and smoke out of the workspace. All laser machines supplied by LasercutMY come with Air Ventilation. Install this ventilation located at the back of the laser cutting machine.

Step 4 : Connect the Power Cable 

Plug the power cable into the machine, ensuring that the plug is not shared with machines that use high electricity, such as a Heat Press or CNC Machine. 

Step 5 : Obtain the Machine ID 

The number ID can be found on the Motherboard, consisting of 2 rows of letters and numbers. 

Step 6 : Connect the USB Cable to the cable

Step 7 : Connect the Orange Dongle to the Computer 

The machine cannot operate if this dongle is not installed. 

Step 8 : Turn on the Laser Machine.

The installation of the Laser Machine is complete, and it is ready for use. 

 You are all set and you can start to create your products.